Effect of Different Incubation Time on Goat's Milk Dadih on Thorny Bamboo (Bambusa stenostachya Hackel)

Authors

  • Anif Mukaromah Wati Brawijaya University
  • Mei Jen Lin
  • Lilik Eka Radiati

DOI:

https://doi.org/10.21776/ub.jitek.2022.017.02.2

Keywords:

Goat's milk dadih, incubation time, thorny bamboo

Abstract

The purpose of this study was to determine the quality of dadih with bamboo in Taiwan, namely Thorny bamboo (Bambusa stenostachya Hackel) with different incubation times. The materials used are bamboo tubes, banana leaves and Alpine goat's milk from the National Pingtung University of Science and Technology (NPUST) Taiwan. Dadih is made by pasteurizing goat's milk at a temperature of 65oC for 30 minutes, allowed to stand until a temperature of 30oC, the milk is poured into a bamboo tube and covered with banana leaves, then fermented in an incubator at 37oC with time variations (0, 24, 30, 36, 42, and 48 hours). The results showed that the difference in incubation time significantly (p<0.05) on pH, total acidity, syneresis, and general characteristics of dadih. The conclusion of this study is 24-hours incubation is the best time to make dadih because the taste is similar to dadih in West Sumatra.

Downloads

Published

2022-07-29

Issue

Vol. 17 No. 2 (2022)

Section

Articles

License

Copyright (c) 2022 Anif Mukaromah Wati, Mei Jen Lin, Lilik Eka Radiati

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Authors who publish with this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
    2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
    3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).